Maybe a dumb question: why did you go with the Roton Torqspline rather than the originally specified ACME rod? I didn't see any discussion around that.
I am willing to contribute to the cost of a tap, if you need one.
Looking very good. This design can be adapted easily to other methods of support structures, but will be interesting to see how much support is needed.
Cheers to the team.
I am willing to contribute to the cost of a tap, if you need one.
Looking very good. This design can be adapted easily to other methods of support structures, but will be interesting to see how much support is needed.
Cheers to the team.