@nicholas.seward
Dia 7/16" lead screw:
Cool, bigger = better (tu)
Sleeves:
Tell me more about the design, is it's purpose to act as an anti backlash nut?
Does it prevent the main nut from rotating, why do you think it work so well?
*Putting about 5lbf on the extruder only moves it about 1mm. (I didn't measure that is just my guess.)
What component do you think is flexing the most, and/or what joint is the weak link?
Delta router:
Do you think it could handle a flexible shaft attached to a remotely mounted Dremel tool as it is now?
If not what would you change?
It would be very useful to be able to true up holes in the Z axis after/during printing.
A quick change tool holder would be a nice feature to add.
Dia 7/16" lead screw:
Cool, bigger = better (tu)
Sleeves:
Tell me more about the design, is it's purpose to act as an anti backlash nut?
Does it prevent the main nut from rotating, why do you think it work so well?
*Putting about 5lbf on the extruder only moves it about 1mm. (I didn't measure that is just my guess.)
What component do you think is flexing the most, and/or what joint is the weak link?
Delta router:
Do you think it could handle a flexible shaft attached to a remotely mounted Dremel tool as it is now?
If not what would you change?
It would be very useful to be able to true up holes in the Z axis after/during printing.
A quick change tool holder would be a nice feature to add.