It's the combination of zero play / all 3 same length / bearings in the same plane that I keep going through. Glue is great for zero play / not so great for adjustment. Clamps are ok for play / ok for adjustment.
I worry a bit about PVC and heat. At least when you use it for water pipe, you derate it pretty fast as the temperate goes up. I'd like to be able to heat the enclosure if needed. It seems to be something that gets done on large(r) printers. The PVC structure pipes could be outside the heated area, so they are less of an issue.
I worry a bit about PVC and heat. At least when you use it for water pipe, you derate it pretty fast as the temperate goes up. I'd like to be able to heat the enclosure if needed. It seems to be something that gets done on large(r) printers. The PVC structure pipes could be outside the heated area, so they are less of an issue.