Thanks. In my configuring I was told to make sure EEPROM was commented out. So I will wait until I play with that. Haven't made a first print yet.
So I understand. I'm tunning a delta with mechanical endstop switched. My carriages have no screws.
i was under the impression when the endstops were hit, it set everything to zero.
But my issue now is setting the X Y Z min. Bed level. I'm close. I have adjusted the Marlins in my case 297. Then I play with a script in Repetier Host and just change the G0 z5. Trying to get to Z0, then go back to marlins and change the manual z min.
So, when M666 comes into play. If my Z is off 2mm I could make a M666 X0 Y0 Z5 And that would say my Z is off by 5 mm. Can that go both directions? Z-5?
I'm close but no Cigare yet.
Alex
So I understand. I'm tunning a delta with mechanical endstop switched. My carriages have no screws.
i was under the impression when the endstops were hit, it set everything to zero.
But my issue now is setting the X Y Z min. Bed level. I'm close. I have adjusted the Marlins in my case 297. Then I play with a script in Repetier Host and just change the G0 z5. Trying to get to Z0, then go back to marlins and change the manual z min.
So, when M666 comes into play. If my Z is off 2mm I could make a M666 X0 Y0 Z5 And that would say my Z is off by 5 mm. Can that go both directions? Z-5?
I'm close but no Cigare yet.
Alex