@Uncle Bob
If the budget gets over $1K for a 2X, well, that is expected and not an issue.
The firmware is indeed what may steer me towards purchasing an RSMax for now, although I have the feeling that I will regret that decision (vs. the Lisa) almost immediately... :(
@Nicholas,
Thank you for the info.
I build lots of things, so I am not too concerned about that, I just would prefer to purchase the best I can with my money. :)
If you think that the RSMax will be equivalent in print quality to the Lisa, then I may go this route for now.
On the other hand, I have that fresh TechShop membership that is only waiting to be used.
I love to build things, as long as I know that the end results will be worth it.
I would certainly be very frustrated if I had lots of issues that I could not resolve because my knowledge is not good enough in that domain. (Firmware programming for example).
Once I get a little bit more feedback, I will decide which route to go.
I appreciate your support.
If the budget gets over $1K for a 2X, well, that is expected and not an issue.
The firmware is indeed what may steer me towards purchasing an RSMax for now, although I have the feeling that I will regret that decision (vs. the Lisa) almost immediately... :(
@Nicholas,
Thank you for the info.
I build lots of things, so I am not too concerned about that, I just would prefer to purchase the best I can with my money. :)
If you think that the RSMax will be equivalent in print quality to the Lisa, then I may go this route for now.
On the other hand, I have that fresh TechShop membership that is only waiting to be used.
I love to build things, as long as I know that the end results will be worth it.
I would certainly be very frustrated if I had lots of issues that I could not resolve because my knowledge is not good enough in that domain. (Firmware programming for example).
Once I get a little bit more feedback, I will decide which route to go.
I appreciate your support.