Re: RepRap 3DR Delta printer Released

Couldn't help sharing my overnight progress. Had a helluva time getting the lower jaw to stick to the platform without getting knocked off about 1cm in, but enabled the raft feature in Cura which seems to have done the trick. It looks like either the X or Y towers got stuck and lost a few steps right at the teeth split line, but it seems to have recovered nicely. It kinda gives it some character and grit. This one is done at 0.2mm with 10% fill. I think it'd be fine with much lower fill now that I see it

[www.thingiverse.com]