Thanks for your comments HaDe,
I'm playing a little with driver voltage in order to find the smoothest configuration.
What I have seen it that when it moves slow it vibrates much more, this effect is also more notable in the lowest layers... I have also set the travel speed to 200mm/s, I think it's fine.
My delta segmentation is also set at 100, I don't know if I should go under that point to reduce vibration...
And finally, I'm confident of the design, it's only 50mm higher than RichRap's original and the assembly is perfect. As I said the only thing that vibrates is the arm carriage, due to the bearings or the steppers (I should also try ABS 3D printed bearings in order to eliminate the possibility of the vibrations in the linear bearings).
I'll post my investigations and if anyone has more clues just let me know ;)
I'm playing a little with driver voltage in order to find the smoothest configuration.
What I have seen it that when it moves slow it vibrates much more, this effect is also more notable in the lowest layers... I have also set the travel speed to 200mm/s, I think it's fine.
My delta segmentation is also set at 100, I don't know if I should go under that point to reduce vibration...
And finally, I'm confident of the design, it's only 50mm higher than RichRap's original and the assembly is perfect. As I said the only thing that vibrates is the arm carriage, due to the bearings or the steppers (I should also try ABS 3D printed bearings in order to eliminate the possibility of the vibrations in the linear bearings).
I'll post my investigations and if anyone has more clues just let me know ;)