OK. see your point. As pronterface uses mm/min, I estimate 5mm/s equals 300mm/min.
I was already set at 400mm/min, but with the rate set at 300mm/min (5mm/s) as you suggest, the extruder still only pushes 16mm of filament towards the hot end (through the tube) when I try to send 100mm.
I was already set at 400mm/min, but with the rate set at 300mm/min (5mm/s) as you suggest, the extruder still only pushes 16mm of filament towards the hot end (through the tube) when I try to send 100mm.