some new photo of running printer
![DSCN0886.JPG]( "DSCN0886.JPG")
First print was cube, but second was this :)
![DSCN0910.JPG]( "DSCN0910.JPG")
![DSCN0913.JPG]( "DSCN0913.JPG")
During building must be change size of the magnets, now it use d=6mm, H=8mm, N42 (power 1,3kg). Problem was when bowden is attached and platform move on opposite side.
What should be done:
Change hotbed holder for easy calibration.
Finish the upper part to hide the electronics and make some spool holder on top.
What should be change for next printer:
the upper part should have a different location for the electronics. Current is unnecessarily high and have below it free space.
First print was cube, but second was this :)
During building must be change size of the magnets, now it use d=6mm, H=8mm, N42 (power 1,3kg). Problem was when bowden is attached and platform move on opposite side.
What should be done:
Change hotbed holder for easy calibration.
Finish the upper part to hide the electronics and make some spool holder on top.
What should be change for next printer:
the upper part should have a different location for the electronics. Current is unnecessarily high and have below it free space.