Sure, all these experimentations increase your knowledge and makes you be prepared for potencial future events, hehehe.
As for vibrations... all are gone with your Slic3r settings!! thank you very much again, it has been a big help. I have tweaked a little bit them to meet my printer, hotend, etc and now I'm printing the first part that I can consider 99% perfect. So, finally I can assure the "3DR with extensions" works fine with no mechanical problems =)
Anyway, the points you have listed seems very interesting and I'll investigate them ir order to improve printing precision.
Other thing I have discovered while testing is that the printable area is squared, I mean, my theoretical printable area is a circle of 26cm of diameter but it takes the circumscribed square, that is a 18.38cm. I have no idea by now if it's a Slic3r limit or if it's "engraved" in the firmware. Trying a Slic3r setting with a printable area which contains a circumscribed square of 26cm goes to 36.77cm but it doesn't works so in my opinion is inside firmware... but, it's strange that Repetier Host lets me move in any position inside this 26cm circle. Any idea?
As for vibrations... all are gone with your Slic3r settings!! thank you very much again, it has been a big help. I have tweaked a little bit them to meet my printer, hotend, etc and now I'm printing the first part that I can consider 99% perfect. So, finally I can assure the "3DR with extensions" works fine with no mechanical problems =)
Anyway, the points you have listed seems very interesting and I'll investigate them ir order to improve printing precision.
Other thing I have discovered while testing is that the printable area is squared, I mean, my theoretical printable area is a circle of 26cm of diameter but it takes the circumscribed square, that is a 18.38cm. I have no idea by now if it's a Slic3r limit or if it's "engraved" in the firmware. Trying a Slic3r setting with a printable area which contains a circumscribed square of 26cm goes to 36.77cm but it doesn't works so in my opinion is inside firmware... but, it's strange that Repetier Host lets me move in any position inside this 26cm circle. Any idea?