Quote
JohnSL
I've just published Building the 3DR “Simple” Delta Printer, Part III on my blog. I believe I have one final part to publish, which is about installing the firmware and calibrating the printer. RichRap has done a great job, so I can just cover what's specific to this printer.
Thanks for the update! I believe I'm now done with everything except for running a few wires and printing the newer style bed clips (in progress). I didn't have tools available to mill my extrusion to run the wires internally, so I'm going to bundle all the motor wires and just run them up the back of one of the pieces of extrusion together. Other than that I'm ready to have a go at the firmware and calibration whenever that post goes up :)
Untitled by Senior Kabong, on Flickr