Yes, it puts it right in front of the tower.
The issue I was having while following that (or a very similar) routine, was that when I got the end to 0.1 above the bed at the towers (using M666), it would crash into the center of the bed...
As I adjusted smooth rod offset up to compensate, it wouldn't make enough of a difference.
The issue I was having while following that (or a very similar) routine, was that when I got the end to 0.1 above the bed at the towers (using M666), it would crash into the center of the bed...
As I adjusted smooth rod offset up to compensate, it wouldn't make enough of a difference.