E steps / mm were way off. Seeing as I just stole some values from a random repository of AirTripper's I wasn't surprised.
Measured and set them more correctly at 97/mm. That'll do well enough to keep calibrating.
Now I'm printing a 20X20 test shape pretty well. It's measuring out to be right around 20mm on both sides (20.1X20.5). But, it seems skewed in one direction.
The print is not exactly centered on the bed (Repetier doesn't seem to want to do that when "center" is pressed.), so I wonder if that is why it is skewed in a particular direction...
Any pointers on removing the skew?
Measured and set them more correctly at 97/mm. That'll do well enough to keep calibrating.
Now I'm printing a 20X20 test shape pretty well. It's measuring out to be right around 20mm on both sides (20.1X20.5). But, it seems skewed in one direction.
The print is not exactly centered on the bed (Repetier doesn't seem to want to do that when "center" is pressed.), so I wonder if that is why it is skewed in a particular direction...
Any pointers on removing the skew?