Quantcast
Channel: Reprap Forum - Delta Machines
Viewing all articles
Browse latest Browse all 20291

Re: Delta bed levelling

$
0
0
Wow, I wish I had known that sooner...

But my eeprom should contain all the values found in config.h as last time I compiled I used a <>0 besides one, which forces eeprom to be overridden


And to answer, no I havent found a solution, I'll pull values from eeprom and check that they match config.h.

I actually just got back on this today after giving up a few weeks ago.

Will update l8r


Update, yea no luck. EEPROM contains same steps/mm that are calculated out in config.h

So, nope, same damn issue.




I'm going to give in, and try software levelling, but I doubt that's going to make a difference unless it can be told that points F,L,R need to be lower.

Another issue I am having is software stops just dont work with Repetier firmware for me. You tell the bot to go to a size way outside of its area, and it will try to go... :-(

I really may just try Marlin Delta. I've had too many complaints about repetier firmware after having such good luck with marlin on my cartesian.

Viewing all articles
Browse latest Browse all 20291

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>