Hey Andy,
Could supply me with the delta dimensions you used in your configuration.h? (even better if you could post your configuration.h so i can have a look!)
• Center-to-center distance of the holes in the diagonal push rods. (i appreciate that my rods will differ slightly here)
• Horizontal offset from middle of printer to smooth rod center.
• Horizontal offset of the universal joints on the end effector.
• Horizontal offset of the universal joints on the carriages.
I believe these are the only cherry pi specific dimensions needed for the firmware?
I've collected most of the hardware and i'm waiting on some of the printed parts. While i'm waiting i'm planning of getting my firmware set up to a basic level.
Many thanks,
Charlie
Could supply me with the delta dimensions you used in your configuration.h? (even better if you could post your configuration.h so i can have a look!)
• Center-to-center distance of the holes in the diagonal push rods. (i appreciate that my rods will differ slightly here)
• Horizontal offset from middle of printer to smooth rod center.
• Horizontal offset of the universal joints on the end effector.
• Horizontal offset of the universal joints on the carriages.
I believe these are the only cherry pi specific dimensions needed for the firmware?
I've collected most of the hardware and i'm waiting on some of the printed parts. While i'm waiting i'm planning of getting my firmware set up to a basic level.
Many thanks,
Charlie