Quote
vreihen
I'd just settle for any electronics board and firmware that labels the steppers A/B/C instead of X/Y/Z for a Delta printer! With both Cartesian and Delta settings in one config file, it gets confusing real quick when you're trying to figure out things like whether the X software endstop applies to the tower carriage range of travel or how far the print head is allowed to move in the X direction when configuring a Delta from scratch.....
Try my APrinter firmware! It does exactly that, and M114 will in fact print both the XYZ and ABC positions. And you can even move the ABC manually with G1, for testing/calibration purposes. Note you'll need one of the supported ARM based controllers, the AVR is too slow and has too little RAM to work nicely with my firmware for delta.
