Any chance there is anyone here who has made, found, or can make an extruder drive body for use with the E3D Bowden hotend that also utilizes the geared stepper extruder as shown in the attached picture. (What a run on sentence!) I plan on mounting on the 2020 aluminum extrusions on a 3DR Delta Printer.
[attachment 27158 makergear.jpg]
Ive been using a direct drive stepper, which works great, but i wanted to get a little more fine control. Really hope someone might chime in. :)
Ive made a few sad attempts, so i figured it was time to see what else is out there.
Thanks for looking!
[attachment 27158 makergear.jpg]
Ive been using a direct drive stepper, which works great, but i wanted to get a little more fine control. Really hope someone might chime in. :)
Ive made a few sad attempts, so i figured it was time to see what else is out there.
Thanks for looking!