Ok. I have 500mm smoth rods, i did the diagonal rods with 210mm (from center to center of the ball ends) and i can get one arm completely vertical when the other 2 are completely horizontal.
Now i have 410mm where the vertical carriages can travel, so if i´m not wrong i should be able to get something around 150mm of printing height.
I will also do the math to see what i get.
Now i have 410mm where the vertical carriages can travel, so if i´m not wrong i should be able to get something around 150mm of printing height.
I will also do the math to see what i get.