Just to clarif, the problem isn't that the frame isn't tight. When everything is tightened down it is rock solid - just not straight. The lengths of the rods are all the same, but something apears to be twisted. It's like the top triangle and bottom triangle don't want to line up right. The top one is rotated a few degrees from the bottom. This is what causes the wobbling that I was talking about when it is on it's side.
What would this do to the print if I can't fix it? Would it make the print have the same type of twist?
-Lucas
What would this do to the print if I can't fix it? Would it make the print have the same type of twist?
-Lucas