I did see that one too but it relies too much on the nozzle tip being completely clean prior to calibration. I guess a simple wipe script would solve that problem.
I'm going to hold off auto bed leveling until i've got my print quality a bit better. One thing at a time!!
The great thing about this printer is how easy it is to modify. I had to take the hot end off yesterday (on my old printer that was a big problem) and it took minutes! Just simply pull the end effector off the magnets and you're half way there!
I'm going to hold off auto bed leveling until i've got my print quality a bit better. One thing at a time!!
The great thing about this printer is how easy it is to modify. I had to take the hot end off yesterday (on my old printer that was a big problem) and it took minutes! Just simply pull the end effector off the magnets and you're half way there!