Hi Charlie
It's got to be worth a try. It's a bit of a job pulling two jumpers off every driver though. My set up is identical to yours and I run 200 delta segments and 1/32 micro stepping. The only difference is that I have the smart graphics display not the full graphics like you. I have printed loads of spiral vase prints from Slic3r with no issues other than the occasional thermal shutdown from a driver. I've dialled the pots down a bit now and it's cured.
Is it only exhibiting with spiral vase prints?
Good luck
Andy
It's got to be worth a try. It's a bit of a job pulling two jumpers off every driver though. My set up is identical to yours and I run 200 delta segments and 1/32 micro stepping. The only difference is that I have the smart graphics display not the full graphics like you. I have printed loads of spiral vase prints from Slic3r with no issues other than the occasional thermal shutdown from a driver. I've dialled the pots down a bit now and it's cured.
Is it only exhibiting with spiral vase prints?
Good luck
Andy