Hey Andy
I might try going down to 1/16 and run a print as see what happens. The stuttering seems to happen on all prints but its especially obvious on the spiral vases.
Also another point i forgot to mention is that the full graphics display is very unresponsive only when the printer is printing.. there definitely seems to be some sort of bottleneck.
Good point about the SD shield - that would certainly cut out the possible problem associated with the display.
I'll keep tinkering! Thanks for all the help Andy
Charlie
I might try going down to 1/16 and run a print as see what happens. The stuttering seems to happen on all prints but its especially obvious on the spiral vases.
Also another point i forgot to mention is that the full graphics display is very unresponsive only when the printer is printing.. there definitely seems to be some sort of bottleneck.
Good point about the SD shield - that would certainly cut out the possible problem associated with the display.
I'll keep tinkering! Thanks for all the help Andy
Charlie
