The link to the OpenScad source file: [www.hck.sk]
General shape is always the same as on the pictures but the dimensions of the parts of the extruder depend on the parameters.
Currently there is 45 of them. The parameters were tested with these two options at least:
[attachment 28017 ext2.jpg]
Edit: extruder.scad file link changed.
General shape is always the same as on the pictures but the dimensions of the parts of the extruder depend on the parameters.
Currently there is 45 of them. The parameters were tested with these two options at least:
- three 608 bearings with M8 home made hobbed bolt;
- one 608 bearing, two 625 flanged bearings, Φ5mm shaft with of-the-shelf pulley (this is on the pictures).
[attachment 28017 ext2.jpg]
Edit: extruder.scad file link changed.