Quote
HaDe
How's your 3DR doing? Have you found points and/or solutions for improvements? I still would like to increase frame stiffness, but have no idea how to get real improvements without a major redesign. The main flex appears to be in the top & bottom printed parts.
It is printing...
[youtu.be]
I had to change somethings. Now running with belt and alu puley. I think it s better than printed parts. Maintenance is also easier than fishing lines. I am also using heated bed...but I think i will not need it anymore since I have discovered the magic of the UHU Stick....(glue stick).
The RAMPS board i have is not delevering 12 V but 5 V, I don t know why. The RAMPS from repradiscount delivered 12 V at the fan port on the board.
Now I am trying to figure out how to add autolevel with Force Sensing Resistors to the system....
[www.youtube.com]
I have learned a lot about the delta and it was a fun to build the 3DR.