Hi all,
I have some good news and bad news.
the good news is my 3DR is alive - somewhat.
The bad news is I can't get it to move via repetier host or pronterface. I don't really know repetier host yet which is why I tried pronterface.
the machine was homing and crashing right past the end-stops until I dropped the homing feedrates down from 200 to 50. Now it homes each axis properly but it just won't move after homing.
I have attached my configuration.h in hopes that someone can take a peek and let me know if they see anything obvious or provide some ideas.
I am using a ramps 1.4 controller with mechanical end-stops. I have looked through Rich's blog on firmware as well as John's blog on firmware and I just can't seem to figure out what's going on.
I have some good news and bad news.
the good news is my 3DR is alive - somewhat.
The bad news is I can't get it to move via repetier host or pronterface. I don't really know repetier host yet which is why I tried pronterface.
the machine was homing and crashing right past the end-stops until I dropped the homing feedrates down from 200 to 50. Now it homes each axis properly but it just won't move after homing.
I have attached my configuration.h in hopes that someone can take a peek and let me know if they see anything obvious or provide some ideas.
I am using a ramps 1.4 controller with mechanical end-stops. I have looked through Rich's blog on firmware as well as John's blog on firmware and I just can't seem to figure out what's going on.