M119 reports the following:
13:57:39.745 : N50 M119 *63
13:57:39.747 : Reporting endstop status
13:57:39.747 : x_max: TRIGGERED
13:57:39.748 : y_max: TRIGGERED
13:57:39.749 : z_max: TRIGGERED
I disabled the x,y,z min end stops using "-1" and reuploaded Marlin. It still does the same thing. It homes just fine but will not move in any axis using manual controls.
13:57:39.745 : N50 M119 *63
13:57:39.747 : Reporting endstop status
13:57:39.747 : x_max: TRIGGERED
13:57:39.748 : y_max: TRIGGERED
13:57:39.749 : z_max: TRIGGERED
I disabled the x,y,z min end stops using "-1" and reuploaded Marlin. It still does the same thing. It homes just fine but will not move in any axis using manual controls.