Umdpru wrote: "I'm in the process of building a 3DR Simple Delta Printer by JohnSL and am now buying all of the vitamins. My one remaining large purchase is the controller. JohnSL uses the Printrboard, however, I am hesitant to use an all-in-one solution in case something "smokes"."
>>>>>>>>>>>>>>>>>>>
Are you converting a Printrbot Simple to a Delta?
I bought a Printrbot Simple kit without the wood frame (no longer on their website as option) and have completed the assembly of a 3DR Simple based on JohnSL design.
However, I am having some difficulty getting the firmware and wiring working properly. So far my motors are doing goofy things.
I need to get my multimeter out and figure it out tomorrow.
OR just bite the bullet and buy the Mega2560/Ramps1.4 and stepper drivers since I have a Mini Kossel up and working, and I know what the firmware settings are for it.
>>>>>>>>>>>>>>>>>>>
Are you converting a Printrbot Simple to a Delta?
I bought a Printrbot Simple kit without the wood frame (no longer on their website as option) and have completed the assembly of a 3DR Simple based on JohnSL design.
However, I am having some difficulty getting the firmware and wiring working properly. So far my motors are doing goofy things.
I need to get my multimeter out and figure it out tomorrow.
OR just bite the bullet and buy the Mega2560/Ramps1.4 and stepper drivers since I have a Mini Kossel up and working, and I know what the firmware settings are for it.