Firmware updates to Printrboard to upload Marlin for 3DR Simple.
[www.printrbottalk.com]
I use a MAC and have to do a bunch of things for Updating Firmware.
I downloaded the Printrbot Firmware Updater and use Arduino IDE to verify/complie and create the HEX file.
Unplug everything, including USB to Printrboard, turn off power or unplug.
Use pre-configured Arduino IDE to modify Marlin code and verify-compile. Note the file name at the end of the list.
For me:
/var/folders/6x/pk1wrcvs07s4b0c067y_3sgw0000gn/T/build6641325177505948607.tmp/Marlin.cpp.hex
Use Terminal app: open $TMPDIR
Drag and drop Marlin.cpp.hex onto Printrbot Firmware Updater app.
Follow the directions exactly.
Remove jumper
Disconnect power and then reconnect power.
Open Repetier, connect and confirm changes.
[www.printrbottalk.com]
I use a MAC and have to do a bunch of things for Updating Firmware.
I downloaded the Printrbot Firmware Updater and use Arduino IDE to verify/complie and create the HEX file.
Unplug everything, including USB to Printrboard, turn off power or unplug.
Use pre-configured Arduino IDE to modify Marlin code and verify-compile. Note the file name at the end of the list.
For me:
/var/folders/6x/pk1wrcvs07s4b0c067y_3sgw0000gn/T/build6641325177505948607.tmp/Marlin.cpp.hex
Use Terminal app: open $TMPDIR
Drag and drop Marlin.cpp.hex onto Printrbot Firmware Updater app.
Follow the directions exactly.
Remove jumper
Disconnect power and then reconnect power.
Open Repetier, connect and confirm changes.