Take a photo of where your endstops are connected on your controller. Good lighting and macro is preferred.
Quote
lilpoof
My endstops are wired for normally closed. When I send M119 without any of the switches touched I get
>>> M119
SENDING:M119
Reporting endstop status
x_max: open
y_max: open
z_max: open
And when I send M119 with me touching one of the switches I get the same thing. I just noticed when I take my voltmeter to the min pins the meter reads 5 volts but the max pins give me nothing.
I have attached my pins.h file