Hi Folks,
I did check bed clearance at the centre and each tower, I can also scoot the head right across the bed without it crashing if I use the jog so I don't think the radius is wrong.
I'm away from the printer now until I get back to work tomorrow but plan to try some handcrafted Gcode to see what happens. I can check segments per second then too but I'm pretty sure it's the same as the default smoothieware config.
Cheers,
Robin.
I did check bed clearance at the centre and each tower, I can also scoot the head right across the bed without it crashing if I use the jog so I don't think the radius is wrong.
I'm away from the printer now until I get back to work tomorrow but plan to try some handcrafted Gcode to see what happens. I can check segments per second then too but I'm pretty sure it's the same as the default smoothieware config.
Cheers,
Robin.