Your experience and mine run in parallel paths.
Yesterday I took the Airtripper Extruder off my Mini Kossel and replaced it with the Greg's Wade Extruder off my 3DR.
Earlier I had bought a Ubis hotend to replace the E3D. Last night it finally worked reliably for a 5mm pyramid test print.
The 3DR Ubis hot end will replace the Ubis on my Simple that had a broken thermistor that I replaced but is now unreliable due to wire shorting intermittently so I need to take it off and rebuild it to insulate the wires better, or stop them from bending.
Hoping to print more parts for Eggbot, also planing on building Watercolorbot and Mirobot (as seen on kickstarter).
Take Care.
Yesterday I took the Airtripper Extruder off my Mini Kossel and replaced it with the Greg's Wade Extruder off my 3DR.
Earlier I had bought a Ubis hotend to replace the E3D. Last night it finally worked reliably for a 5mm pyramid test print.
The 3DR Ubis hot end will replace the Ubis on my Simple that had a broken thermistor that I replaced but is now unreliable due to wire shorting intermittently so I need to take it off and rebuild it to insulate the wires better, or stop them from bending.
Hoping to print more parts for Eggbot, also planing on building Watercolorbot and Mirobot (as seen on kickstarter).
Take Care.