"Ok, turns out it was the heatbed expanding/contracting as it was being powered on/off maintaining the set temperature. Expanding would make the entire print raise closer to the hotend causing the filament to squish outwards, while contracting would move the print further away reducing the width of the extrude and likely overlapping the previous perimeter."
Example of the heated bed, his was "constantly on" as well. I bring my point back up, have you checked that it isn't the heated bed?
Are the waves the same distance from eachother on all models? Or closer together the longer it takes each layer?
Example of the heated bed, his was "constantly on" as well. I bring my point back up, have you checked that it isn't the heated bed?
Are the waves the same distance from eachother on all models? Or closer together the longer it takes each layer?