Andy,
What firmware do you use into the RAMPS? Marlin?
Also, I would like to add a 25mm (I took the mesurement of the Sunon MC25101V1000UA99) fan for the J-Head as it seems recommended for PLA. I would hook it only on the bottom (red arrow) ?
![f5H0vdq.jpg]( "f5H0vdq.jpg")
(SketchUp : [stuff.quebecit.net] )
Does it make sens to you?
I'm asking cause, since I dont have the printer yet, it's hard for me to figure how it will fit. Plus, it will be printed in ABS and I wont be able to do it with the printer.
What firmware do you use into the RAMPS? Marlin?
Also, I would like to add a 25mm (I took the mesurement of the Sunon MC25101V1000UA99) fan for the J-Head as it seems recommended for PLA. I would hook it only on the bottom (red arrow) ?
(SketchUp : [stuff.quebecit.net] )
Does it make sens to you?
I'm asking cause, since I dont have the printer yet, it's hard for me to figure how it will fit. Plus, it will be printed in ABS and I wont be able to do it with the printer.