Hi Andy,
Thank you for answer. I was not aware about the fact you sell printers. I understood the point. I am working in SW and Catia and I do not know Schetup, this is the reason I asked about igs or step files. I can do the redesign by measuring stl and redoing the part in SW/Catia but I would like to cut the long way. The STL can not be modified neither in SW nor in Catia or at least I did not discover the way. Anyway, I like your design, and I think it is very intelligent. For me I would like to convert it for Nema23 motors (I have a lot from scrap printers), and the position on top instead of bottom, and to implement 2 hot ends together with z probing done by hot end instead of one.
Thank you for answer. I was not aware about the fact you sell printers. I understood the point. I am working in SW and Catia and I do not know Schetup, this is the reason I asked about igs or step files. I can do the redesign by measuring stl and redoing the part in SW/Catia but I would like to cut the long way. The STL can not be modified neither in SW nor in Catia or at least I did not discover the way. Anyway, I like your design, and I think it is very intelligent. For me I would like to convert it for Nema23 motors (I have a lot from scrap printers), and the position on top instead of bottom, and to implement 2 hot ends together with z probing done by hot end instead of one.