Hi Vreihen, thanx for your answer.
The M119 replies Max on all axis so I assume that it´s correct.
I suppose that I have the right stepper connected to corresponding end switch.
Isn´t the input pins, Xmin, Xmax, Ymin, Ymax, Zmin, Zmax from left to right on ramps? I only use the top row and middle row connected directly to the microswitches (Normally Open). Am I right?
Best regards
Wretan
The M119 replies Max on all axis so I assume that it´s correct.
I suppose that I have the right stepper connected to corresponding end switch.
Isn´t the input pins, Xmin, Xmax, Ymin, Ymax, Zmin, Zmax from left to right on ramps? I only use the top row and middle row connected directly to the microswitches (Normally Open). Am I right?
Best regards
Wretan