So i ended up with this settings:
// Center-to-center distance of the holes in the diagonal push rods.
#define DELTA_DIAGONAL_ROD 222.0 // mm
// Horizontal offset from middle of printer to smooth rod center.
#define DELTA_SMOOTH_ROD_OFFSET 175.0 // mm
// Horizontal offset of the universal joints on the end effector.
#define DELTA_EFFECTOR_OFFSET 33.0 // mm
// Horizontal offset of the universal joints on the carriages.
#define DELTA_CARRIAGE_OFFSET 22.0 // mm
with
#define MANUAL_Z_HOME_POS 175
i already did some printing tests on a 20x20mm and its base come out 20.20mm..some calibration needed...and the distance between the nozzle and the bed is fine at the center, but not on the edges. Still some work to do.
// Center-to-center distance of the holes in the diagonal push rods.
#define DELTA_DIAGONAL_ROD 222.0 // mm
// Horizontal offset from middle of printer to smooth rod center.
#define DELTA_SMOOTH_ROD_OFFSET 175.0 // mm
// Horizontal offset of the universal joints on the end effector.
#define DELTA_EFFECTOR_OFFSET 33.0 // mm
// Horizontal offset of the universal joints on the carriages.
#define DELTA_CARRIAGE_OFFSET 22.0 // mm
with
#define MANUAL_Z_HOME_POS 175
i already did some printing tests on a 20x20mm and its base come out 20.20mm..some calibration needed...and the distance between the nozzle and the bed is fine at the center, but not on the edges. Still some work to do.