Hi,
I´ve tested the segments per mm, parameter, but with no succsess. i played with acallaration and jerk, too, nothing better.
At the moment i have no idea what the reason could be :(.
i made a triangel to all three towers, i go to tower a, b to c and to x0y0 always ca 0.2 nozzel lift. But from x0y0 to tower c it is fine.
i made one more video [youtu.be] .
At the moment i would nothting rather doing than print with a perfect adjusted cherry pi, because i love the desing.
i also made a test without the spring, same result.
thank you much
I´ve tested the segments per mm, parameter, but with no succsess. i played with acallaration and jerk, too, nothing better.
At the moment i have no idea what the reason could be :(.
i made a triangel to all three towers, i go to tower a, b to c and to x0y0 always ca 0.2 nozzel lift. But from x0y0 to tower c it is fine.
i made one more video [youtu.be] .
At the moment i would nothting rather doing than print with a perfect adjusted cherry pi, because i love the desing.
i also made a test without the spring, same result.
thank you much