Sure I can!
[youtu.be]
Sorry it took so long - been busy at work.
As you can see its not excessive but it is apparent.
No I have NOT calibrated this as of yet - just the basic measurements entered into marlin.
Again - all my towers are at a perfect 120 degree separation and parallel. all the pullys are the same (20 tooth aluminum), and the stepper motor steps is at 80 in Marlin.
All 6 rods are exact length (done in a jig)
Thanks!
Jeff
[youtu.be]
Sorry it took so long - been busy at work.
As you can see its not excessive but it is apparent.
No I have NOT calibrated this as of yet - just the basic measurements entered into marlin.
Again - all my towers are at a perfect 120 degree separation and parallel. all the pullys are the same (20 tooth aluminum), and the stepper motor steps is at 80 in Marlin.
All 6 rods are exact length (done in a jig)
Thanks!
Jeff
