I'm installing Marlin v1 for the first time (I've been running Repetier for a couple of years). I have two main issues,
I believe I have set the ( #define MANUAL_Z_HOME_POS 286 ) correctly but when I start to print it always prints about an 35mm
above the bed. Then when I run the auto bed leveling everything works except the probe does not touch the bed no matter what I do,
it seems to be about a 10MM high ??
I believe I have set the ( #define MANUAL_Z_HOME_POS 286 ) correctly but when I start to print it always prints about an 35mm
above the bed. Then when I run the auto bed leveling everything works except the probe does not touch the bed no matter what I do,
it seems to be about a 10MM high ??