I did find some 20T pulley sellers, so that is not the problem.
Can you point me in the right direction which firmware parameter has to be changed to reflect these smaller diameters ?
speaking of that, If I consider that the Gcode will ask revs to move x-mm, how do details improve by this upgrade ? It just has to make more rev for the same distance does it not ?
Can you point me in the right direction which firmware parameter has to be changed to reflect these smaller diameters ?
speaking of that, If I consider that the Gcode will ask revs to move x-mm, how do details improve by this upgrade ? It just has to make more rev for the same distance does it not ?