Re: Marlin v1 issues MANUAL_Z_HOME_POS

@ jaguarking11
I'm running MLX 6mm belt width 18 teeth. I'm running 1/32nd steps. I'm not very familiar with Marlin and I see the configuration.h page has string setting, how do I change this to pulley.

@AndyCart
here is the M501 info..thanks


18:22:26.352 : N222 M501 *5
18:22:26.359 : echo:Stored settings retrieved
18:22:26.359 : echo:Steps per unit:
18:22:26.363 : echo: M92 X174.00 Y174.00 Z174.00 E1500.00
18:22:26.363 : echo:Maximum feedrates (mm/s):
18:22:26.367 : echo: M203 X80.00 Y80.00 Z80.00 E200.00
18:22:26.367 : echo:Maximum Acceleration (mm/s2):
18:22:26.371 : echo: M201 X3000 Y3000 Z3000 E3000
18:22:26.371 : echo:Acceleration: S=acceleration, T=retract acceleration
18:22:26.375 : echo: M204 S1000.00 T1000.00
18:22:26.382 : echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s)
18:22:26.383 : echo: M205 S0.00 T0.00 B20000 X10.00 Z10.00 E20.00
18:22:26.383 : echo:Home offset (mm):
18:22:26.388 : echo: M206 X0.00 Y0.00 Z0.00
18:22:26.388 : echo:Endstop adjustment (mm):
18:22:26.388 : echo: M666 X0.00 Y0.00 Z0.00
18:22:26.388 : echo:Delta Geometry adjustment:
18:22:26.395 : echo: M666 A0.00 B0.00 C0.00 E0.00 F0.00 G0.00 R108.40 D217.50 H258.00 P0.00
18:22:26.395 : echo:PID settings:
18:22:26.396 : echo: M301 P15.34 I1.57 D37.45