Re: Where to mount the extruder on Rostock Mini

Quote
Replace
Thanks, this helps. however, the drawer won't make it in my little workbench space :-)

Maybe you could use a Rostock-Mini highboy kit to mount RAMPS board under the base of the printer.

Quote
Replace
Ths extruder clamp is a good solution.
Please let me know which other clamp you use for the kapton covered build plate ?

I used a Parametric Platform Clip with these settings:

// Parameters
Gap = 10.5;
Thickness = 4;
Reach = 25;
// Internals
Width = Gap + Thickness*2;
Height = Thickness + 10;

It's a temporary solution, explained here.

Quote
Replace
Also I notice a (click-on ?) construction on one of each rod units, at the bottom... what is that ?

That's my latest experiment with better lightning so the Octoprint timelapse pictures would look better.
I used 8mm Rod Led Strip Bracket with LED Strip Mount(shortened to 100mm).
It's still too much as the light is still reflecting from the object very much, have to soften the light somehow......