It's, relatively, cheap to build as it uses normal V slot 2020. It incorporates a built in Z probe for auto calibration. The effector is mounted using a ball and socket joint for minimal backlash. The power supply fits neatly under the bed and the wires to the extruder run in one of the V slots and it has an on board filament spool holder. The whole machine is, therefore, neat and tidy and suitable for use in any room in the house. It's also easily transportable as even though it allows a 180 x 180 x 250 build area it's quite compact. It also prints very accurately at 120mm/s.
↧