Hello Fellow Reprapers,
I've built a Reprap Rostock and I'd like to try out the Repetier firmware that can be pre-configured using this nifty tool:
[www.repetier.com]
I've got three mechanical endstops that are placed physically on the top plastic parts.
This form suggests that these endstops should be defined as xmin, ymin and zmin: would this be correct geometrically?
Therefore x, y, z increases as the diagonal rods transverses downwards for each respective tower.
Sorry for the noobish question, information overload I has.
Cheers!
I've built a Reprap Rostock and I'd like to try out the Repetier firmware that can be pre-configured using this nifty tool:
[www.repetier.com]
I've got three mechanical endstops that are placed physically on the top plastic parts.
This form suggests that these endstops should be defined as xmin, ymin and zmin: would this be correct geometrically?
Therefore x, y, z increases as the diagonal rods transverses downwards for each respective tower.
Sorry for the noobish question, information overload I has.
Cheers!