Today my hot end crashed in the build plate, due to a reversed Z-axis while calibrating.
Not a real problem, however, after the crash my motors will not move any more.
The Ramps will reply on m119 correct, but manual control does nothing else.
Can I have fried a Ramps part due to crashing the hptend into the build plate ? Or the motors themselves ? One of the belts came off, so that motor must have been free in moving and not burning..... but none move now.
Thomas
Not a real problem, however, after the crash my motors will not move any more.
The Ramps will reply on m119 correct, but manual control does nothing else.
Can I have fried a Ramps part due to crashing the hptend into the build plate ? Or the motors themselves ? One of the belts came off, so that motor must have been free in moving and not burning..... but none move now.
Thomas