one add:
in the calibration guide in the link above it says:
so if my dimeonsion is too small (95 for example instead of 100) the diagonal-rod-variable should increase.
if i increase my rod-variable the real size gets smaller... how come this?
in the calibration guide in the link above it says:
If the length of the object is wrong, adjust DELTA_DIAGONAL_ROD: new DELTA_DIAGONAL_ROD = 100 / measured_length * original DELTA_DIAGONAL_ROD
so if my dimeonsion is too small (95 for example instead of 100) the diagonal-rod-variable should increase.
if i increase my rod-variable the real size gets smaller... how come this?