Finally to the point where I'm able to print on my Kossel Mini so I decided to enable auto level. I'm used to my cartesian style printers that utilize M212 for adjusting the Z height for layer adhesion but can't find any information about it on the Delta printers. I tried using M666 and while that works for non auto level setups it seems to have no affect once the bed leveling is enabled.
It seems odd this isn't something more common since I have found layer adhesion can change drastically when switching from PLA, ABS, brands and even colors.
Will post some pictures later tonight once I finish dialing it in and clean wiring up(it's a mess).
It seems odd this isn't something more common since I have found layer adhesion can change drastically when switching from PLA, ABS, brands and even colors.
Will post some pictures later tonight once I finish dialing it in and clean wiring up(it's a mess).