Quote
AndyCart
Quote
ChrisT88
Just realized it's #define Z_PROBE_OFFSET_FROM_EXTRUDER that controls the z height. Is there a g code command to adjust this or is the only way by editing and re-uploading the fimware?
Hi Chris
It depends on which version of Marlin. If you use Rich Cattell's version then M666 Pnn.n will do it for you.
Andy
Thanks Andy, exactly the information I was looking for. Seems to be difficult to round up some of this information but I'm getting there. I noticed Rich's code hasn't been updated in 8-9 months and hasn't been taken into the main branch but even still it looks ideal for Delta's unless Repetier or a variation of it is a better option?
For now I'm going to try out Rich's code. Eventually I would like to familiarize myself with the code enough to help consolidate the updates and features as Rich's terminal commands are a must for practical use IMO.
Thanks again.