Delta segments per second 100, max acceleration 4000, Max speed 200, no oscilations noticed so far.
You did not specify segments per second. Lets say it 100. Then your maximum segment size is below 3 mm (but this will not be achieved if you are not printing longer stright lines than 3 mm) and maximu delta segmentation error is 0.006 mm. I do not have any equations for what kind of oscilations may happen. It should not be hard to write them down and check it out.
You did not specify segments per second. Lets say it 100. Then your maximum segment size is below 3 mm (but this will not be achieved if you are not printing longer stright lines than 3 mm) and maximu delta segmentation error is 0.006 mm. I do not have any equations for what kind of oscilations may happen. It should not be hard to write them down and check it out.