hercek Wrote:
-------------------------------------------------------
> Use the measured data whatever way you want. We
> fed them to maxima for more processing. If you
> want to try it too let me know and I'll try to
> brush maxima notebook to be more readable. You
> must have some clue about math and maxima for this
> to be usefull to you:
> [maxima.sourceforge.net]
Is there any chance of you sharing your maxima code and procedure?
I recently installed a probe and am using Johann's deltabot branch. The movement is the "most" level it has ever been, but I still have a couple areas where the effector is ~0.1mm high and I cannot print there. I have an ~8mm thick cast aluminum build plate that is *flat*.
From what you describe, it sounds as if your post-processing code can help identify any possible structural/mechanical issues?
-------------------------------------------------------
> Use the measured data whatever way you want. We
> fed them to maxima for more processing. If you
> want to try it too let me know and I'll try to
> brush maxima notebook to be more readable. You
> must have some clue about math and maxima for this
> to be usefull to you:
> [maxima.sourceforge.net]
Is there any chance of you sharing your maxima code and procedure?
I recently installed a probe and am using Johann's deltabot branch. The movement is the "most" level it has ever been, but I still have a couple areas where the effector is ~0.1mm high and I cannot print there. I have an ~8mm thick cast aluminum build plate that is *flat*.
From what you describe, it sounds as if your post-processing code can help identify any possible structural/mechanical issues?
